This article mainly introduces:

Turkey hydraulic cylinder,servo hydraulic cylinder manufacturer,servo hydraulic cylinder

(Turkey servo hydraulic cylinder,produced by Hengyu Group）

servo hydraulic cylinder are widely used in Turkey，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed servo hydraulic cylinder for customers from Turkey.

Introduction to servo hydraulic cylinder:

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular servo hydraulic cylinder action. Troubleshooting method: Replace the rubber hose.

When the servo hydraulic cylinder is in use, ensure that the servo hydraulic cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

The scar on the sliding surface of the servo hydraulic cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the servo hydraulic cylinder wall. Therefore, before installation, these scars must be fully repaired.

The servo hydraulic cylinder is not the same as the servo hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the servo hydraulic cylinder can not be used as a high-power power component, but the servo hydraulic cylinder can be used as a relatively large power component, or the servo hydraulic cylinder system can be used.

Answers to some questions about servo hydraulic cylinder:

What material should be selected to seal the cylinder?
The choice of material for sealing is related to the working environment, strength, and medium of your equipment.

What is a constant velocity cylinder? What is the difference between hydraulic cylinder and constant velocity cylinder?
The constant speed cylinder should be the same as the speed of the piston rod extension and withdrawal cylinder is called the constant speed cylinder. The difference between it and the ordinary hydraulic cylinder is that the ordinary hydraulic cylinder only has a piston rod extended out, and the general extension speed is slow and the recovery speed is fast, because of the relationship between the effective area. Effective area of piston chamber > Effective area of piston rod chamber. The effective area on both sides of the constant speed cylinder is the same, because there are piston rods sticking out at both ends. The application of constant speed cylinder is most common in grinding machines.