This article mainly introduces:

Chile hydraulic cylinder,reset cylinder manufacturer,reset cylinder

(Chile reset cylinder,produced by Hengyu Hydraulic Cylinder Factory）

reset cylinder are widely used in Chile，because of simple structure and reliable operation，powerful torque，clever hydraulic energy conversion.So our company has designed reset cylinder for customers from Chile.

Introduction to reset cylinder:

The commonly used buffer structure of the reset cylinder is composed of a piston boss and a reset cylinder head groove. When the piston moves close to the reset cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The reset cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

reset cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the reset cylinder head itself is the guide sleeve of the piston rod, the reset cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the reset cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

Most of the failure of the reset cylinder is because there is a foreign body in the reset cylinder into the failure of the reset cylinder, the most problematic is that it is difficult to determine when the foreign body is into the reset cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about reset cylinder:

What is the difference between single acting hydraulic cylinder and double acting hydraulic cylinder?
Single action hydraulic cylinder is a single direction force work, the return of the plunger depends on itself or the weight of the mechanism to return. The double acting hydraulic cylinder is mainly different from the extension and retraction of the piston (the thrust and tension of the saying), which are all operated by the action of liquid pressure.

How to refuel pneumatic riveting cylinder?
First put the gun flat, that is, horizontally, while pushing the stroke positioning pin and loosen the back cover, rotate to the left for a maximum of five turns, and then use a wrench to loosen the oil sealing screw, slowly add the hydraulic oil and let the air out, fill up to tighten the oil sealing screw. This process of adding hydraulic oil is over.